B2005Plus Wet & Dry Mopping
High-end Robot Vacuum Cleaner B2005Plus
Get to know the cleaning effect of B2005Plus
Wet & Dry Mopping
The mop can not only mop the floor, but also drip the water automatically and evenly.
The application of frequency conversion to Robot Vacuum Cleaner B2005Plus and the electric eye installed inside the dust absorption area, makes the robot recognize the dust while it does the cleaning and focus on cleaning
the area with much dust, avoiding the robot
The charm of B2005Plus
Wet & Dry Mopping
The mop can not only mop the floor, but also drip the water
automatically and evenly.
Smart Technology of frequency conversion
Robot vacuum cleaner that can do mopping and
vacuuming better than human power.
B2005Plus has various cleaning modes, including auto cleaning mode, spot cleaning mode, edge cleaning mode, scheduling
Various Cleaning Modes
To explore new territory
The cleaning effect
With 90mm in height, the robot can go through the furniture like sofa, table and bed easily.
Mop of 370 square centimeters does the mopping as
Double Side Brushes
Double side brushes make B2005Plus clean the corners perfectly. Central hole structure avoids the suction inlet
being blocked by rubbish.
Smart Recharging Design
With 90mm in height
The robot will go back to the charging base to recharge at low battery.
The virtual blocker makes the robot work within certain
area where you want it to be cleaned.
With the intelligent infrared introduction of anti-falling, the
robot will automatically recognize the edge and avoid falling down from stairs or tables.
B2005Plus will turn around when it runs to the furniture
then effectively avoids the damage caused by the collision.
The UV light will kill the bacteria on the floor and carpet,
keeping the house clean and healthy.
50DB noise will not disturb you when you are at work and at rest.
Filters prevent secondary pollution
The dust and rubbish is separated so that the suction port will not be blocked. The primary filter and HEPA filter can
filter micro dust and prevent secondary pollution.
Daily maintenance so easy
Clean the Roller Brush
A.Check side brushes for damage or foreign object on the brush.
B.Clean the side brushes
C.Remove the screws of the side brushes, Replace brushes with new ones, Use screws to lock the new brushes in place
Clean Sensors and Charging Poles
Clean the sensors and charging poles per week or according to
daily use to make sure the robot is well maintained.
Wipe the sensor window and auto charging sensors with a soft dry
Clean charging contacts on self charging base.
Clean vacuum intake and dust sensors as shown in the pictures.
Note: After taking out dustbin, check if there is foreign object stuck or block the vacuum passage and clean it if necessary.
A.Press "PUSH" to open the dustbin cover.
B.Take out the dustbin
C.Separate HEPA filter from dustbin.
D.Pull out dustbin top cover and take out primary filter.
E.Empty dustbin and wipe the dust.
F. Wash dustbin with water.
Clean and Replace Filters
Clean filters with cleaning brush tool.
Install primary filter and HEPA filter into dustbin.
Note: 1. Install both HEPA and primary filters when they are dry.
2. Do not place HEPA and primary filters directly in the sun. Close
dustbin cover and install it into main unit
Note: Dustbin and Filters( including HEPA and filter) could be
replaced if needed
How to handle the water tank trailing bar
1.Open the water injection hole, after water injected, stick the mop
to the right place.
2.Aim at the relevant holes and assemble the trailing bar on the
Choose one robot best for you
Cleaning with central brush
Intelligent Dust Detection
About 90 mins